Inspection Procedure 11

DIAGNOSIS

STEP 1. Check the vent plug for clogging.
If clogged, clean or replace the part. Then go to Step 5.
If normal, go to Step 2.

STEP 2. Check the cover installation state.
If incorrect, repair it. Then go to Step 5.
If correct, go to Step 3.

STEP 3. Check the oil seal for wear or damaged.
If worn or damaged, replace the seal. Then go to Step 5.
If normal, go to Step 4.

STEP 4. Check that the oil is not excessive.





Remove the filler plug and check the gear oil level. Check that the gear oil level is not more than 8 mm (0.3 inch) below the bottom of the filler plug hole.
If excessive, adjust it. Then go to Step 5.

STEP 5. Check symptoms.
Check that no oil is leaking.