Windshield Wiper and Washer
WINDSHIELD WIPER AND WASHERREMOVAL AND INSTALLATION
Removal Steps 1-8:
NOTE: For removal and installation of the column switch assembly (windshield wiper and washer switch), refer to Power Steering, Steering Wheel and Shaft.
REMOVAL SERVICE POINT
[A]WIPER MOTOR REMOVAL
CAUTION: Auto-stop angle is controlled so do not remove the crank arm from the wiper motor unless necessary. When removing, mark the crank arm and wiper motor.
Use a flat-tipped screwdriver to remove the connection between the wiper motor crank arm and link assembly.
INSTALLATION SERVICE POINT
]A[WIPER ARM AND BLADE ASSEMBLY INSTALLATION
Install the wiper blade in the specified position (standard value).
Standard value:
Driver's side (A): 26 ± 5 mm (1.0 ± 0.2 inch)
Passenger's side (B): 30 - 40 mm (1.2 - 1.5 inches)