Inspection Procedure 7

INSPECTION PROCEDURE 7: Noise While Turning

DIAGNOSIS

STEP 1.Check the side bearing for wear or damage.
Q: Is the side bearing worn or damaged?
YES: Replace the part. Then go to Step 3.
NO: Go to step 2.

STEP 2.Check the side gear, pinion gear or pinion shaft for damage.
Q: Is the side gear, pinion gear or pinion shaft damaged?
YES: Replace the part. Then go to Step 3.
NO: Go to Step 3.

STEP 3.Check symptoms.
Q: Is the abnormal noise eliminated?
YES: Diagnosis is complete.
NO: Start over at Step 1.