Removal and Replacement

REMOVAL AND INSTALLATION

REMOVAL SERVICE POINTS
[[A]] POWER STEERING OIL PUMP ASSEMBLY / A/C COMPRESSOR ASSEMBLY REMOVAL
1. Remove the oil pump and A/C compressor (with the hose attached).
2. Suspend the removed oil pump (by using wire or similar material) at a place where no damage will be caused during removal/installation of the engine assembly.

[[B]] ENGINE ASSEMBLY REMOVAL
1. Check that all cables, hoses, harness connectors, etc. are disconnected from the engine.
2. Use special tool MB991683 and chain block to lift the engine assembly slowly and remove it.

INSTALLATION SERVICE POINT
]]A[[ ENGINE ASSEMBLY INSTALLATION
Install the engine assembly. When doing so, check carefully that all pipes and hoses are connected, and that none are twisted, damaged, etc.