Door Molding
REMOVAL SERVICE POINT
<
1. Attach protection tape all the way along the edges of the double-sided tape which is still adhering to the body.
2. Use a resin spatula to scrape off the double-sided tape.
3. Peel off the protection tape.
4. Wipe the body surface and clean it with a shop towel moistened with 3M(TM) AAD Part number 8880 or equivalent.
INSTALLATION SERVICE POINTS
>>A<< DOOR MOLDING INSTALLATION.
Double-sided tape affixing to the door molding (When reusing)
1. Scrape off the double-sided tape with a resin spatula or gasket scraper.
2. Use a shop towel moistened with 3M(TM) AAD Part number 8880 or equivalent to wipe the molding surface.
CAUTION: Do not remove all of the residual adhesive.
3. Remove only a small portion of the residual adhesive.
CAUTION:
- Always apply it evenly on the entire surface, because a lot or little will reduce its strength.
- Do not touch the painted surface.
4. Affix the specified double-sided tape to the door molding.
DOOR MOLDING INSTALLATION.
1. Tear off the double-sided tape backing paper.
NOTE: If you attach the adhesive tape to the edge of the backing paper, it will be easy to tear off
2. Install the door molding.
NOTE: If the double-sided tape is difficult to affix in cold temperature, etc., warm the bonding surfaces of the body and door molding to about 40 - 60 °C (104 - 140 °F) before affixing the tape.
3. Firmly press in the door molding.