Exterior Moulding / Trim: Service and Repair

GRILL MOLDING And GARNISH - Part 1:

Part 2:

Remove the radiator grill by pushing all tabs of the radiator grill clips in the direction of the arrows with a flat-tipped screwdriver, then lightly pull the radiator grill toward you.

<> ROOF DRIP MOLDING REMOVAL

CAUTION: If the moulding has become warped, it should not be reused.
Use special tool MB990449 to lever out the molding.

<> DOOR MOULDING REMOVAL

1. Attach protection tape all the way along the edges of the double-sided tape which is still adhering to the body.

2. Use a resin spatula to scrape off the double-sided tape.
3. Peel off the protection tape.
4. Wipe the body surface and clean it with a shop towel moistened with 3M(TM) AAD Part number 8880 or equivalent.

INSTALLATION SERVICE POINTS

>>A<< DOOR MOLDING INSTALLATION.
Double-sided tape affixing to the door molding (When reusing)

1. Scrape off the double-sided tape with a resin spatula or gasket scraper.

2. Use a shop towel moistened with 3M(TM) AAD Part number 8880 or equivalent to wipe the molding surface.

CAUTION: Do not remove all of the residual adhesive.

3. Remove only a small portion of the residual adhesive

CAUTION:
- Always apply it evenly on the entire surface, because a lot or little will reduce its strength.
- Do not touch the painted surface.

4. Affix the specified double-sided tape to the door molding.

DOOR MOLDING INSTALLATION.
1. Tear off the double-sided tape backing paper.

NOTE: If you attach the adhesive tape to the edge of the backing paper, if will be easy to tear off

2. Install the door molding.

NOTE: If the double-sided tape is difficult to affix in cold temperature, etc., warm the bonding surfaces of the body and door molding to about 40 - 60°C (104 - 140°F) before affixing the tape.

3. Firmly press in the door molding.