Countershaft Gear
DISASSEMBLY AND REASSEMBLY
DISASSEMBLY SERVICE POINTS
<> BALL BEARING REMOVAL
Use special tool MD998801 to remove the ball bearing.
<> SPACER/ROLLER BEARING/INNER RACE REMOVAL
1. Remove the spacer and roller bearing.
2. Use special tools MD998801 and MD998368 to remove the inner race.
NOTE: In the case that the installation of the spacer, roller bearing, and inner race is in reverse order according to the vehicle, then remove the inner race, roller bearing and spacer at the same time.
REASSEMBLY SERVICE POINTS
>>A<< INNER RACE/ROLLER BEARING/SPACER INSTALLATION
1. Use special tools MD998812 and MD998818 to install the inner race.
2. Install the roller bearing and spacer.
>>B<< SNAP RING INSTALLATION
1. Install the thickest snap ring that can be fitted into the snap ring groove of the counter shaft gear.
2. Make sure that the counter shaft gear roller bearing end play meets the standard value.
Standard value: 0 - 0.08 mm (0 - 0.003 inch)
>>C<< BALL BEARING INSTALLATION
Use special tools MD998812 and MD998818 to install the ball bearing.