Generator and Drive Belt

REMOVAL AND INSTALLATION

Required Special Tool:
^ MD998781: Flywheel Stopper

REMOVAL SERVICE POINT
[[A]] CRANKSHAFT BOLT LOOSENING





1. Using special tool MD998781, hold the drive plate.
2. Remove the crankshaft bolt.

INSTALLATION SERVICE POINT
]]A[[ CRANKSHAFT BOLT TIGHTENING





1. Using special tool MD998781, hold the drive plate.





2. Clean the bolt hole in crankshaft bolt and damper pulley's seating surface.
3. Degrease the cleaned seating surface of the damper pulley.
4. Install the damper pulley.
5. Apply oil to the threads of crankshaft bolt and the outer surface of washer.
6. Tighten the crankshaft bolt to the specified torque.
Tightening torque: 185 ± 5 Nm (139 ± 3 ft. lbs.)