Ignition System

IGNITION SYSTEM

REMOVAL AND INSTALLATION

Removal Steps 1-6:

Required Special Tools:
^ MD998781: Flywheel Stopper

REMOVAL SERVICE POINT

[A] CAMSHAFT POSITION SENSING CYLINDER REMOVAL





1. Using special tool MD998781, hold the drive plate or flywheel.
2. Loosen the camshaft position sensing cylinder bolt.

INSTALLATION SERVICE POINT

[A] CAMSHAFT POSITION SENSING CYLINDER INSTALLATION





1. Using special tool MD998781, hold the drive plate or flywheel.
2. Tighten the camshaft position sensing cylinder bolt to the specified torque.
Tightening torque: 22 ± 4 Nm (16 ± 3 ft-lb)

[B] CAMSHAFT POSITION SENSOR SUPPORT INSTALLATION





Apply a 3 mm (0.12 inch) diameter bead of sealant (Three bond 1207F or equivalent) to the camshaft position sensor support.