Front Axle Hub
FRONT AXLE HUB ASSEMBLYREMOVAL AND INSTALLATION
CAUTION
^ Do not strike the ABS rotors installed to the BJ outer race of driveshaft against other parts when removing or installing the driveshaft. Otherwise the ABS rotors will be damaged.
^ Be careful not to strike the pole piece at the tip of the front ABS sensor with tools during servicing work.
Post-installation Operation:
Removal Steps 1-13:
Required Special Tools:
^ MB990767: Front Hub and Flange Yoke Holder
^ MB990242: Puller Shaft
^ MB990244: Puller Bar
^ MB991354: Puller Body
^ MB990211: Slide Hammer
^ MB991897:Ball Joint Remover
REMOVAL SERVICE POINTS
[A] DRIVESHAFT NUT REMOVAL
CAUTION
Do not apply pressure to wheel bearing by the vehicle weight to avoid possible damage when driveshaft nut is loosened.
Use special tool MB990767 to fix the hub and remove the driveshaft nut.
[B] CALIPER ASSEMBLY REMOVAL
1. Remove the caliper assembly with brake hose.
2. Secure the removed caliper assembly with a wire or other similar material at a position where it will not interfere with the removal and installation of the front wheel hub assembly and knuckle.
[C] BRAKE DISC REMOVAL
If the brake disc is seized, install a M8 x 1.25-mm bolts as shown, and remove the disc by tightening the bolts evenly and gradually.
[D] SELF LOCKING NUT (CONNECTION FOR TIE ROD END) REMOVAL
CAUTION
^ Do not remove the nut from the ball joint. Loosen it and use the special tool to avoid possible damage to ball joint threads.
^ Hang the special tool with a cord to prevent from falling.
1. Install the special tool MB991897 as shown in the figure.
2. Turn the bolt and knob as necessary to make the jaws of special tool MB991897 parallel, tighten the bolt by hand and confirm that the jaws are still parallel.
NOTE: When adjusting the jaws in parallel, make sure the knob is in the position shown in the figure.
3. Tighten the bolt with a wrench to disconnect the tie rod end and remove the self locking nut.
[E] FRONT WHEEL HUB ASSEMBLY REMOVAL
1. Use special tools MB990242, MB990244, MB991354 and MB990767 to push out the driveshaft from the hub and knuckle.
2. If the front wheel hub is seized, remove the knuckle together with front wheel hub and fix them with a vise.
3. Hang the driveshaft on the vehicle body with a rope.
4. Use special tools MB990244, MB991354 and MB990211 to pull out the front wheel hub from the knuckle.
INSTALLATION SERVICE POINT
[A]WASHER/ DRIVESHAFT NUT INSTALLATION
CAUTION
Before securely tightening the driveshaft nuts, make sure there is no load on the wheel bearings. Otherwise the wheel bearings will be damaged.
1. Be sure to install the driveshaft washer in the specified direction.
2. Using special tool MB990767, tighten the driveshaft nut. At this time, tighten the nut to the specified lower limit torque so that the pin hole may align with cotter pin.
Tightening torque: 196 - 255 Nm (145 - 188 ft-lb)
3. If the pin hole does not align with the pin, tighten the driveshaft nut [less than 255 Nm (188 ft-lb)] and find the nearest hole, then fit the cotter pin.