Removal and Replacement

POWERTRAIN CONTROL MODULE (PCM)

REMOVAL AND INSTALLATION

CAUTION:
- Do not replace the PCM and the ETACS-ECU simultaneously. Always replace either one of the ECUs first, and register the encrypted code. Then, replace the other ECU.
- After the PCM is replaced, idling speed may be unstable because the MFI engine learning is not completed. To make it stable, make the system learn the idling.

[VEHICLES FOR USA]

Removal Steps 1-4:

[VEHICLES FOR CANADA]

Removal Steps 1-5:

REMOVAL SERVICE POINT

[[A]] BREAK-OFF BOLTS REMOVAL







1. Drill in the break-off bolt a hole deep enough for the tap to stand.
2. Remove the break-off bolt with a left-hand tap.

INSTALLATION SERVICE POINTS

]]A[[ BREAK-OFF BOLTS INSTALLATION
Tighten until the head of break-off bolt is broken off.

]]B[[ INITIALIZATION PROCEDURE
Turn the ignition switch on then off, and keep it off for at least 10 seconds.