Shift Linkage: Service and Repair
TRANSAXLE CONTROLREMOVAL AND INSTALLATION
CAUTION
^ When removing and installing the transaxle control cable and shift lock cable unit, be careful not to hit the SRS-ECU.
Pre-removal & Post-installation Operation:
Assembly Removal Steps 1-7:
INSTALLATION SERVICE POINTS
[A] SHIFT LOCK CABLE UNIT INSTALLATION
1. Selector lever to P position.
2. Turn the ignition key to "LOCK" (OFF) position.
3. Install the rod of the shift lock cable unit to the lock cam, push the lever in direction A, push the shift lock cable unit in direction B and tighten the bolt at the standard torque.
Tightening torque: 5.0 ± 1.0 Nm (44 ± 9 in-lb)
4. Check the selector lever operation. Selector Lever Operation Check.
[B] TRANSAXLE CONTROL CABLE (TRANSAXLE SIDE)/ADJUSTING NUT INSTALLATION
1. Place the selector lever and manual control lever in the "N" position.
2. Place the cable stud into the manual control lever slot and install the nut loosely. Gently push the transaxle control cable into the manual control lever slot until the cable is taut. Tighten the nut to the specified torque.
Tightening torque: 12 ± 2 Nm (107 ± 17 in-lb)
INSPECTION
Check the cable assembly for function and for damage.