Rear Wiper and Washer

REAR WIPER AND WASHER

REMOVAL AND INSTALLATION

Post-installation Operation:

Removal Steps 1-8:

NOTE: For removal and installation of the wiper and washer switch, refer to Chassis Electrical, Column switch.

INSTALLATION SERVICE POINTS

]]A[[ REAR WIPER ARM AND BLADE ASSEMBLY INSTALLATION







Before installing the rear wiper arm and blade assembly, operate the rear wiper motor so that the motor stops at the predetermined park position. Install the rear wipe arm and blade assembly and adjust the rear wiper blade position so that the blade end stops at the predetermined position (standard position).

Standard value (A): 40 ± 5 mm (1.57 ± 0.20 inches)

]]B[[ WIPER BLADE RUBBER/WIPER BLADE ASSEMBLY INSTALLATION







CAUTION: Use a curved backing like that shown for the backing of a wiper blade rubber to ensure sustained wiper wiping performance.