Oxygen Sensor: Service and Repair

REMOVAL AND INSTALLATION [3.0L ENGINE]









REMOVAL SERVICE POINTS

[[A]] EXHAUST TAIL PIPE DIFFUSER REMOVAL





Insert the wood and tire lever between exhaust tail pipe diffuser and exhaust main muffler.
And then turn the tire lever and remove exhaust tail pipe diffuser.

[[B]] RIVET REMOVAL

CAUTION:
Be careful not to damage the heat protector with the drill.





Use a drill [6.0 mm (0.24 inch)] to make a hole in the rivet to break it, and then remove the rivet.

INSTALLATION SERVICE POINT

]]A[[ RIVET INSTALLATION





Use a rivet tool shown in the illustration to connect the parts with rivets by the following procedures.
1. Insert the rivet into a corresponding location.
2. Set the rivet tool at a portion A of rivet.
3. While pushing the flange surface of the rivet onto parts to be fixed with the rivet tool, press the handle of the tool.
4. Thin part of portion A of the rivet will be cut off and the part is fixed in position.