Inspection

INSPECTION

FRONT WASHER MOTOR INSPECTION





1. The front washer motor must be checked with the washer tank installed and the washer fluid filled.
2. Connect the battery to the washer motor connector as shown. Check that the washer motor delivers washer strongly to the front washer hose side.

WINDSHIELD WASHER FLUID EJECTION CHECK

NOTE:
The splashing point cannot be adjusted by the nozzle. If the splashing point of the washer fluid is different from the figure below, replace the nozzle.





NOTE:
Use special tool Adjustment tool, washer nozzle (MB992326) to adjust the splashing points of the nozzle.

ADJUSTMENT OF THE MIST TYPE WASHER NOZZLE INJECTION POSITION

CAUTION:
Do not use tools other than the special tool (MB992326) to adjust the injection angle because the washer nozzle may get damaged.

CAUTION:
Adjust the splashing position within the specified adjustment range, otherwise the windshield cannot be washed properly.

1. Use special tool Adjustment tool, washer nozzle (MB992326) to adjust the splashing points of the nozzle.

2. Insert the mist type washer nozzle adjusting side of the special tool Adjustment tool, washer nozzle (MB992326) into the injection part of the mist type washer nozzle as shown in figure (A).









3. Move the special tool Adjustment tool, washer nozzle (MB992326) up and down to adjust the angle of the washer nozzle as shown in figure (B).





NOTE:
If the washer nozzle cannot be moved smoothly, adjust the angle while pressing the special tool Adjustment tool, washer nozzle (MB992326) against the washer nozzle.





WINDSHIELD WASHER SWITCH CHECK

Check the windshield washer switch from the ETACS diagnostic trouble codes for proper operation. Electronic Time and Alarm Control System (ETACS))