Interior Moulding / Trim: Service and Repair
REMOVAL AND INSTALLATION
CLIP AND CLAW POSITIONS
NOTE:
Each number in the illustration indicates a part number.
REMOVAL SERVICE POINTS
[[A]]FRONT PILLAR TRIM REMOVAL
1. Pull down the front or rear pillar trim as shown in the figure.
2. Cut the clip at the cutting position shown in the figure, taking care not to damage the other components.
3. Remove the clip remaining on the front or rear pillar trim, taking care not to scratch the trim.
4. Remove the clip remaining on the vehicle side by breaking it to prevent damage to the flange of the clip mounting hole.
[[B]] CENTER PILLAR TRIM CAP/QUARTER TRIM UPPER CAP REMOVAL
Remove the opening trim. Remove the trim cap by inserting the special tool ornament remover (MB990784) between the trim and body as shown in the illustration.