Component Tests and General Diagnostics

CRUISE CONTROL SYSTEM COMPONENT CHECK

CRUISE CONTROL SWITCH CHECK

1. Remove the cruise control switch (Refer to Service and Repair.)





2. Measure the resistance between terminal number 2 and terminal number 3 when each of the "ON/OFF", "CANCEL", "COAST/SET" and "ACC/RES" switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance values are correct.





3. Check that the cruise control switch illuminates when a positive battery terminal is connected to the connector terminal number 4, and terminal number 1 is grounded.

STOPLIGHT SWITCH CHECK

Testing and Inspection.

CLUTCH SWITCH CHECK [M/T]

Testing and Inspection.

TRANSMISSION RANGE SWITCH CHECK [CVT]

Testing and Inspection.

THROTTLE ACTUATOR CONTROL MOTOR CHECK

Testing and Inspection.