Keyless Operation System (KOS)

DTC U0195: Satellite radio tuner CAN time-out

CAUTION:

- If DTC U0195 is set to the ETACS-ECU, always diagnose the CAN bus line.
- Before replacing the ECU, ensure that the communication circuit is normal.

TROUBLE JUDGMENT

If the signal from satellite radio tuner cannot be received, the KOS-ECU sets DTC U0195.

TROUBLESHOOTING HINTS

- The satellite radio tuner may be defective.
- The KOS-ECU may be defective.
- The CAN bus may be defective.

DIAGNOSIS

STEP 1. Using scan tool MB991958, diagnose the CAN bus line.

(1)
CAUTION:
To prevent damage to scan tool (MB991958), always turn the power supply mode of the engine switch to the OFF position before connecting or disconnecting scan tool (MB991958).

Connect scan tool MB991958. Refer to "How to connect the scan tool (M.U.T.-III) Reading and Clearing Diagnostic Trouble Codes."

(2)Turn the power supply mode of the engine switch to ON.

(3)Diagnose the CAN bus line.

(4)Turn the power supply mode of the engine switch to OFF.

Q. Is the CAN bus line found to be normal?

YES Go to Step 2.
NO Repair the CAN bus line CAN Bus Diagnostics Chart).
STEP 2. Using scan tool MB991958, read the satellite radio tuner diagnostic trouble code.

Check if DTC is set to the satellite radio tuner.

Q. Is the DTC set?

YES Troubleshoot the satellite radio Satellite Radio Tuner).
NO Go to Step 3.
STEP 3. Using scan tool MB991958, read the other system diagnostic trouble code.

Check if DTC U0195 is set to the combination meter.

Q. Is the DTC set?

YES Go to Step 4.
NO Go to Step 5.
STEP 4. Recheck for diagnostic trouble code.

Check again if the DTC is set to the KOS-ECU.

(1)Erase the DTC.

(2)Turn the power supply mode of the engine switch from OFF to ON.

(3)Check if DTC is set.

(4)Turn the power supply mode of the engine switch to OFF.

Q. Is the DTC set?

YES Replace the satellite radio tuner.
NO The trouble can be an intermittent malfunction How to Cope With Intermittent Malfunctions).
STEP 5. Recheck for diagnostic trouble code.

Check again if the DTC is set to the KOS-ECU.

(1)Erase the DTC.

(2)Turn the power supply mode of the engine switch from OFF to ON.

(3)Check if DTC is set.

(4)Turn the power supply mode of the engine switch to OFF.

Q. Is the DTC set?

YES Replace KOS-ECU and register the ID codes (Refer to ID Codes Registration Procedure).
NO The trouble can be an intermittent malfunction How to Cope With Intermittent Malfunctions).