Keyless Operation System (KOS)
DTC U1415: Coding not completed/Data fail
CAUTION:
- If the DTC U1415 is set, diagnose the CAN bus lines.
- When replacing the ECU, always check that the communication circuit is normal.
DIAGNOSTIC FUNCTION
If the vehicle information data is not registered to the combination meter, the KOS-ECU sets the DTC U1415.
JUDGMENT CRITERIA
With the global coding counter value "0," if all the global coding data (vehicle information) are not stored, the KOS-ECU determines that a problem has occurred.
TROUBLESHOOTING HINTS
- The CAN bus line may be defective.
- The KOS-ECU may be defective.
- The ETACS-ECU may be defective.
DIAGNOSIS
STEP 1. Using scan tool MB991958, diagnose the CAN bus line.
(1)
CAUTION:
To prevent damage to scan tool (MB991958), always turn the power supply mode of the engine switch to the OFF position before connecting or disconnecting scan tool (MB991958).
Connect scan tool MB991958. Refer to "How to connect the scan tool (M.U.T.-III) Reading and Clearing Diagnostic Trouble Codes."
(2)Turn the power supply mode of the engine switch to ON.
(3)Diagnose the CAN bus line.
(4)Turn the power supply mode of the engine switch to OFF.
Q. Is the CAN bus line found to be normal?
YES Go to Step 2.
NO Repair the CAN bus line CAN Bus Diagnostics Chart).
STEP 2. Using scan tool MB991958, read the ETACS-ECU diagnostic trouble code.
Check if a coding-related DTC is set to the ETACS-ECU.
Q. Is the DTC set?
YES Troubleshoot the ETACS-ECU. Refer to Electronic Time and Alarm Control System (ETACS).
NO Go to Step 3.
STEP 3. Recheck for diagnostic trouble code.
Check again if the DTC is set to the KOS-ECU.
(1)Erase the DTC.
(2)Turn the power supply mode of the engine switch from OFF to ON.
(3)Check if DTC is set.
(4)Turn the power supply mode of the engine switch to OFF.
Q. Is the DTC set?
YES Replace KOS-ECU and register the ID codes (Refer to ID Codes Registration Procedure.)
NO The trouble can be an intermittent malfunction How to Cope With Intermittent Malfunctions).