With Scan Tool

READ OUT OF DIAGNOSTIC TROUBLE CODE
Precautions For Operation
(1) When battery voltage is low, no detection of failure is possible. Be sure to check the battery for voltage and other conditions before starting the test.
(2) On-board diagnostic item is erased if the battery of the engine control module connector is disconnected. Do not disconnect the battery before the diagnostic result is completely read.




USING SCAN TOOL
(1) Switch OFF the ignition switch.
(2) Connect the power-source terminal of the scan tool to the cigarette lighter socket.
(3) Connect the scan tool to the data link connector.
(4) Turn ignition switch to ON.
(5) Using the scan tool, read out and make a note of the on-board diagnostic output.
(6) Refer to the diagnostic chart, and repair the indicated location of malfunction.
(7) Erase the diagnostic trouble code.










DIAGNOSTIC CHART










TROUBLESHOOTING TABLE