Oxygen Sensor: Service and Repair

Oxygen Sensor:

***UPDATED BY TSB# ENG023, DECEMBER, 1990
NOTE: Contact with a rust penetrant such as WD-40 will render an Oxygen Sensor inoperative. If a rust penetrant is used to remove, or contact prior to installation is made with the oxygen sensor, discard the sensor.

To replace the Oxygen Sensor, proceed as follows:
Removal:


1. Disconnect the harness terminal.
2. Remove the sensor with a suitable socket or wrench.
Installation:
3. Apply a thin coating of anti-seize compound to the threads.
NOTE: Do Not contaminate the sensor tip with compound.
4. Install the sensor and torque to 29-36 ft.lb...
5. Apply a thin coating of dielectric compound to the connector.
6. Connect harness terminal.