Rear Wipers
REAR WIPER & WASHER SWITCH1989 Models
Fig. 37 Rear Wiper & Washer Connector Identification:
1. Operate switch and ensure continuity between terminals as shown in Fig. 37.
High & Low Speed Operation Check
1. Connect battery positive to terminal 1 and battery negative to terminal 5, ensure low speed operation.
2. Connect battery positive to terminal 1 and battery negative to terminal 2, ensure high speed operation.
Automatic Stop Operation Check
1. Operate motor at low speed.
2. Stop motor anywhere except at the off position by disconnecting terminal 5.
3. Connect terminal 5 to terminal 6, connect battery positive to terminal 1.
4. Ensure motor stops at the off position after motor operates again.
1990-92 WIPER MOTOR
Wiper Operation Check
Fig. 38 Rear Wiper Motor Connector Identification:
1. Connect battery positive to terminal 1 and battery negative to terminal 4, ensure motor runs, Fig. 38.