Engine: Service and Repair

1. Release fuel system pressure as outlined under Technician Safety Information.
2. Remove cruise control pump and link assembly as outlined in Cruise Control.
3. Mark and remove hood assembly.
4. Remove air hose and air pipe assembly.
5. Remove front exhaust pipe assembly.
6. Remove transaxle assembly as outlined under Transmission and Drivetrain.
7. Remove radiator assembly.

Fig. 9 Engine Assembly Replacement (Part 1 Of 2):

Fig. 9 Engine Assembly Replacement (Part 2 Of 2):

8. Remove engine assembly in numbered sequence as shown, Fig. 9, noting the following:
a. Disconnect air conditioner compressor and power steering oil pump leaving hoses connected.
b. Using suitable engine lifting device, raise and support engine to remove weight off mounts, then remove engine mount bracket as outlined under Engine Mount.
c. Ensuring cables, hoses and wire harness connectors are removed, raise engine assembly upward out of engine compartment.
9. Reverse procedure to install, Fig. 9, noting the following:
a. Ensure all cables hoses and wire harness connectors are in correct position before completing engine installation.

Fig. 3 Engine Mounting Stopper Installation:

b. Ensure arrow mark on stopper is in direction shown, Fig. 3, when attaching engine mounting bracket.