Intake Manifold

Intake Manifold

REMOVAL AND INSTALLATION

Removal Steps 1-14:

INSTALLATION SERVICE POINTS




A INTAKE MANIFOLD INSTALLATION (DOHC)
1. Tighten the intake manifold bolts, noting that the bolts installed at the locations indicated in the illustration are tightened to a different torque.




B WATER OUTLET FITTING GASKET INSTALLATION (FOR RUBBER COATED METAL GASKET ONLY)
1. Install the water outlet lifting gasket with its "UP" mark facing up (toward the water outlet fitting side).




D SEALANT APPLICATION TO THERMOSTAT HOUSING

Specified sealant: Mitsubishi Genuine Part No. MD970389 or equivalent

NOTE:
1. Be sure to install the housing quickly while the sealant is wet (within 15 minutes).
2. After installation, keep the sealed area away from oil and coolant for approx. 1 hour.




F SEALANT APPLICATION TO ENGINE COOLANT TEMPERATURE SENSOR
Specified sealant: 3M Nut Locking Part No.4171 or equivalent




G SEALANT APPLICATION TO ENGINE COOLANT TEMPERATURE GAUGE UNIT
Specified sealant: 3M ATD Part No.8660 or equivalent