Operation CHARM: Car repair manuals for everyone.

Rectangular Waterproof Connector

Foreword
Connectors which are loose shall be rectified by removing the female terminal from connector housing and raising its lance to establish a more secure engagement. Removal of connector terminal used for MFI and ELC-4 A/T control circuit shall be done in the following manner.

Rectangular Waterproof Connector (Part 1 Of 3):





1. Disengage front holder by using a screwdriver and remove it.

Rectangular Waterproof Connector (Part 2 Of 3):





2. Insert tip of screwdriver [* 0.8 mm (0.03 in.) width] into connector in a manner as shown in the figure, push it lightly to raise housing lance and pull out harness.
* If right size screwdriver is not available, convert a conventional driver to suit the size.

Rectangular Waterproof Connector (Part 3 Of 3):





3. Press contact point of male terminal down by holding a screwdriver [1.4 mm (0.06 in.) width] in a manner as shown in the figure.