Upper, Front

Front Suspension (4WD)
1. Raise and support front of vehicle and remove wheel.
2. Remove shock absorber upper attaching bolt, if necessary.
3. Using suitable jack, raise lower link and remove ball joint tightening nut.
4. Press ball joint out of knuckle spindle, then remove the upper link spindle.
5. Remove ball joint attaching nuts, then the ball joint,
6. Remove nuts and washers from both ends of upper link spindle, then press spindle and bushings out of link.
7. Reverse procedure to install.
8. Always adjust wheel alignment after removal and installation of suspension parts.