Spark Plug: Service and Repair

REPLACEMENT
1. Disconnect ignition wires from spark plugs at boot. Do not pull on the wire.
2. Remove spark plugs with spark plug wrench.
3. Check spark plug gap of each new spark plug.

Gap: 0.8-0.9 mm (0.031-0.035 in)

4. Install spark plugs. Reconnect ignition wires according to numbers indicated on them.

NOTE: When installing spark plugs to No. 2 and 4 cylinders, securely fit each ignition wire mounting hole onto the ignition wire fixing pin.

Spark plug torque: 20-29 Nm (14-22 ft lb)