2WD M/T Models For California

1. Install throttle position sensor body in throttle body. Do not tighten bolts.
2. Connect closed throttle position switch harness connector. Do not connect throttle position sensor connector.
3. Start engine and warm it up sufficiently.
4. Turn diagnostic test mode to mode IV.
5. Depress accelerator pedal and release slowly.
6. Check engine rpm when red LED on ECM is turned on.

Closed throttle position switch ON-OFF: 1 ,OOO ± 150 rpm

7. If it is out of specification, adjust switch by turning throttle position sensor body.
8. Turn engine off and remove air duct.
9. Tighten securing bolts, install air duct and connect throttle position sensor connector.
10. Recheck engine ON-OFF rpm