Work Support Mode

WORK SUPPORT DIAGNOSTIC TEST MODES
WORK ITEM: THRTL POS SEN ADJ
Condition:
Check the throttle position sensor signal. Adjust it to the specified value by rotating the sensor body under the following condition.
- IGN SW "ON"
- ENG not running
- ACC pedal kept OFF

Usage:
When adjusting throttle position sensor initial position.

WORK ITEM: IACV-AAC/V ADJ
Condition:
Set engine rpm at the specified value under the following condition.
- ENG warmed up enough
- No load

Usage:
When adjusting idle speed.

WORK ITEM: FUEL PRES RELEASE
Condition:
- Fuel pump will stop by touching start during idle.
Crank a few times after engine stall.

Usage:
When releasing fuel pressure.