Collision Diagnosis

Collision Diagnosis
To repair the SRS Supplemental "AIR BAG", perform the following steps. When supplemental air bag deployed in a collision:

1 Replace the diagnosis (control) unit.
2 Remove the supplemental air bag module.
3 Check the SRS components using the table shown below:
- If the SRS components are showing any visible damage such as dents, cracks, or deformation, replace them with new ones.
4 Conduct self-diagnosis using CONSULT or Supplemental "AIR BAG" warning lamp to ensure entire SRS operates properly except open circuits of air bag module.
5 Install new supplemental air bag module.
6 Conduct self-diagnosis again, and erase the memory using CONSULT or the "AIR BAG" warning lamp.

Important:
- "AIR BAG" warning lamp will continue to flash if:
1. Erasing is not performed.
2. System is not returned to user mode.
3. Malfunctioning parts are not completely repaired.

7 Turn ignition switch "ON". "AIR BAG"warning lamp should come on for about 7 seconds, then go off.

When supplemental air bag did not deploy in a collision:
1 Check the SRS components using the table shown below:
- If the SRS components are showing any visible damage such as dents, cracks, or deformation, replace them with new ones.
2 Conduct self-diagnosis using CONSULT or Supplemental "AIR BAG" warning lamp to ensure entire SRS operates properly.





SRS inspection