Keyless Entry: Service and Repair

Enter the identity (ID) code manually when:
^ remote controller or multi-remote control unit is replaced.
^ an additional remote controller is activated.

ID Code Entry Procedure
To enter the ID code, follow this procedure.

"Setting mode":
(1) Close and lock all doors.
(2) Insert and remove the key from the ignition more than six times within 10 seconds. (The side marker lamps, tail lamps license lamps and interior illumination lamps will then flash twice.)
^ At this time, the original ID codes are eliminated.

ID code entry:
(3) Turn ignition key to ACC position.
(4) Push lock button on the new remote controller once (for example, if door is locked using the remote controller during this ID code entry enable state, a new ID code can be entered).
^ At this time, the new ID code is entered. (The side marker lamps, tail lamps, license lamps and interior illumination lamps will then flash twice.)

Additional ID code entry
(5) If you need to activate additional remote controllers, unlock the driver's door, then lock again with door lock knob.
(6) Push lock button on the additional new remote controller once.
(7) This ID code entry enable state and setting mode remain until the driver's door is opened.

NOTE
^ If you need to activate more than two additional new remote controllers, repeat the procedure "Additional ID code entry" for each new remote controller.
^ If the same ID code that exists in the memory is input, the side marker lamps, tail lamps, license lamps and interior illumination lamps will flash twice but the entry will be ignored.
^ Entry of maximum four ID codes is allowed and any attempt to enter more will be ignored.
^ Any ID codes entered after termination of the "setting mode" will not be accepted. Additionally remote control signals will be inhibited when an ID code has not been entered during the "setting" mode.
^ The lighting switch should be off while in "Setting mode" to ensure correct operation (lamp flashing).