Keyless Entry: Testing and Inspection

Trouble Symptom

NOTE:
^ The unlock and panic alarm operation of the multi-remote control system does not activate with the ignition key inserted in the ignition key cylinder.
^ The lock operation of the multi-remote control system does not activate with the key inserted in the ignition key cylinder or if one of the doors is opened.

Diagnostic Procedure 1

Check remote controller battery.

NOTE: Remote controller does not function if battery is not set correctly.

Diagnostic Procedure 2

Check antenna of multi remote control system.

Diagnostic Procedure 3

All remote controls do not function even if remote controller is operated properly.

Diagnostic Procedure 4

Side marker lamps, tail lamps, license lamps and interior illumination lamps do not flash twice when pressing lock button of remote controller. Everything else functions.

Diagnostic Procedure 5

Interior lamp do not turn on for 30 seconds when pressing unlock button of remote controller. Everything else functions.

ELECTRICAL COMPONENTS INSPECTION

Door Switches

Check continuity between terminals when door switch is pushed and released.

Door Lock Actuator (Door Unlock Sensor)

Check continuity between terminals when door is locked and unlocked.

Key Switch (Insert)

Check continuity between terminals when key is inserted in ignition key cylinder and key is removed from ignition key cylinder.

ID Code Entry Procedure

Enter the identity (ID) code manually when:
^ remote controller or control unit is replaced.
^ an additional remote controller is activated.

ID Code Entry Procedure

To enter the ID code, follow the procedures in the image.

NOTE:
^ If you need to activate more than two additional new remote controllers, repeat the procedure "Additional ID code entry" for each new remote controller.
^ If the same ID code that exists in the memory is input, the entry will be ignored.
^ Entry of maximum of four ID codes is allowed and any attempt to enter more will be ignored.