Transmission Position Sensor/Switch: Adjustments

Park/Neutral Position (PNP) Switch Adjustment





1. Remove control linkage and manual lever from manual shaft.
2. Set manual shaft in "N" position.
3. Loosen Park/Neutral Position (PNP) switch fixing bolts.
4. Insert pin into adjustment holes in both Park/Neutral Position (PNP) switch and manual as near vertical as possible.
5. Tighten Park/Neutral Position (PNP) switch fixing bolts.
6. Remove pin.
7. Reinstall any part removed.
8. Adjust control linkage. Refer to "Control Cable Adjustment".
9. Check continuity of Park/Neutral Position (PNP) switch.