Collision Diagnosis

To repair the SRS, perform the following steps.

When SRS is activated in a collision:
1. Replace the air bag diagnosis sensor unit.
2. Remove the air bag modules.
3. Check the SRS components using the table shown in the diagram.
Replace any SRS components showing visible signs of damage (dents, cracks and deformation).

4. Install new air bag modules.
5. Conduct Self-diagnosis. Refer to "SRS Operation Check". Ensure entire SRS operates properly.

When SRS is not activated in a collision:









1. Check the SRS components using the table.
Replace any SRS components showing visible signs of damage (dents, cracks and deformation).

2. Conduct Self-diagnosis using CONSULT and "AIR BAG" warning lamp. Refer to "SRS Operation Check""DIAGNOSTIC PROCEDURE 1". Ensure entire SRS operates properly.