Fog/Driving Lamp: Service and Repair

Removal and Installation
1. Disconnect front fog lamp harness connector and separate front fog lamp connector from front fog lamp bracket.




2. Remove mounting nut and remove lens and housing assembly from front fog lamp bracket.
3. Install in reverse order of removal. Ensure top of lens faces up.
4. Tighten mounting nut.
With Tightening Torque: 5 - 6 Nm (0.51 - 0.61 kg.m, 44.3 - 53.1 in.lb)




Bulb and Lens Replacement
1. Remove the two metal clips on sides of fog lamp.
2. Pull out and support fog lamp lens.
3. Disconnect fog lamp bulb connector.




4. Lift retaining spring.
5. Remove fog lamp bulb.
- Fog lamp bulb cannot be separated from wire and is serviced as an assembly.
6. For lens replacement, disconnect ground connector from bulb retainer and remove lens.
7. Install in reverse order of removal. Ensure top of lens faces up.
DO NOT TOUCH BULB.