Diagnosis Function

CAUTION:
Do not use electrical test equipment on any circuit related to the SRS unless instructed to. SRS wiring harnesses are covered with yellow insulation either just before the harness connectors or on the complete harness, for easy identification.

Do not attempt to repair, splice or modify the SRS wiring harness. If the harness is damaged, replace it with a new one.

Keep ground portion clean.




DIAGNOSIS FUNCTION
The SRS Self-diagnosis results can be read by using "AIR BAG" warning lamp, "SEAT BELT" warning lamp and/or CONSULT-II. The reading of these results is accomplished using one of two modes - "User mode" and "Diagnosis mode".
The User mode is exclusively prepared for the customer (driver). This mode warns the driver of a system malfunction through the operation of the "AIR BAG" warning lamp and/or the "SEAT BELT" warning lamp. The Diagnosis mode allows the technician to locate and inspect the malfunctioning part.
The mode applications for the "AIR BAG" warning lamp, "SEAT BELT" warning lamp and CONSULT-II are as follows:

DIAGNOSIS MODE FOR CONSULT-II

SELF-DIAG [CURRENT]
A current Self-diagnosis result (also indicated by the number of warning lamp flashes in the Diagnosis mode) is displayed on the CONSULT-II screen in real time. This refers to a malfunctioning part requiring repairs.

SELF-DIAG [PAST]
Diagnosis results previously stored in the memory are displayed on the CONSULT-II screen. The stored results are not cleared until memory erasing is executed.

TROUBLE DIAG RECORD
With "TROUBLE DIAG RECORD", diagnosis results previously erased by a reset operation can be displayed on the CONSULT-II screen.




ECU DISCRIMINATED NO.
The air bag diagnosis sensor unit for each vehicle model is assigned with its own individual classification number. This number will be displayed on the CONSULT-II screen, as shown. When replacing the air bag diagnosis sensor unit, refer to the part number for compatibility. After installation, replacement with a correct unit can be checked by confirming this classification number on the CONSULT-II screen.

IMPORTANT
For NISSAN MODEL WD22, the air bag diagnosis sensor unit classification number assigned is A6F4.

HOW TO CHANGE SELF DIAGNOSIS MODE

WITH CONSULT-II




From User Mode to Diagnosis Mode
Touch "AIRBAG" on the "SELECT SYSTEM" screen. User mode automatically changes to Diagnosis mode.




From Diagnosis Mode to User Mode
Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears. Diagnosis mode automatically changes to User mode.

WITHOUT CONSULT-II




From User Mode to Diagnosis Mode
Diagnosis mode can be activated only when a malfunction is detected, by pressing the front door switch LH at least 5 times within 7 seconds after turning the ignition switch ON. SRS will not enter Diagnosis mode if no malfunction is detected.

From Diagnosis Mode to User Mode
To return to User mode while a malfunction is being detected, turn ignition switch OFF, then back ON and press the front door switch LH at least 5 times within 7 seconds.

After a malfunction is repaired, turn ignition switch OFF for at least one second, then back ON. Diagnosis mode returns to User mode.