General Specifications
| Cylinder Block Distortion | Limit | 0.1 | ||
| Cylinder Bore | Inner Diameter | Grade 1 | Standard | 89.000 - 89.010 |
| Limit | 0.2 Wear Limit | |||
| Grade 2 | Standard | 89.010 - 89.020 | ||
| Limit | 0.2 Wear Limit | |||
| Grade 3 | Standard | 89.020 - 89.030 | ||
| Limit | 0.2 Wear Limit | |||
| Out-Of-Round (X - Y) | Standard | Less Than 0.015 | ||
| Taper (A - B) | Standard | Less Than 0.010 | ||
| Difference In Inner Diameter Between Cylinders | Standard | Less Than 0.03 mm | ||
| Limit | 0.2 mm | |||
| Cylinder Block Height (From crankshaft center) | Standard | 246.95 - 247.05 | ||
| Limit | 0.2 |