High Clutch

DISASSEMBLY AND ASSEMBLY





Service procedures for high clutch are essentially the same as those for reverse clutch, with the following exception:





^ Check of high clutch operation





^ Removal and installation of return spring





^ Inspection of high clutch return springs
Inspection standard: Refer to Specifications.





^ Inspection of high clutch drive plate
Thickness of drive plate:
Standard: 1.52 - 1.67 mm (0.0598 - 0.0657 inch)
Wear limit: 1.40 mm (0.0551 inch)





^ Measurement of clearance between retaining plate and snap ring
Specified clearance:
Standard: 1.8 - 2.2 mm (0.071 - 0.087 inch)
Allowable limit: 3.2 mm (0.126 inch)
Retaining plate: Refer to Application and ID.