Collision Diagnosis

To repair the SRS, perform the following steps.

When SRS is activated in a collision:
1. Replace the diagnosis sensor unit.
2. Remove the air bag modules and seat belt pre-tensioner assemblies.
3. Check the SRS components using the table shown:
- Replace any SRS components showing visible signs of damage (dents, cracks and deformation).

4. Install new air bag modules and seat belt pre-tensioner assemblies.
5. Conduct self-diagnosis using CONSULT-II or "AIR BAG" warning lamp. Refer to "SRS Operation Check". [1][2]Component Tests and General Diagnostics
Ensure entire SRS operates properly.

When SRS is not activated in a collision:
1. Check the SRS components using the table shown:
- Replace any SRS components showing visible signs of damage (dents, cracks and deformation).

2. Conduct self-diagnosis using CONSULT-II or "AIR BAG" warning lamp. Refer to "SRS Operation Check". [1][2]Component Tests and General Diagnostics
Ensure entire SRS operates properly.

Part 1:

Part 2:

SRS INSPECTION