ID Code Entry Procedure

ID Code Entry Procedure:

ID Code Entry Procedure

NOTE:
- If a remote controller is lost, the ID code of the lost remote controller must be erased to prevent unauthorized use. To erase all ID codes in memory, register one ID code (remote controller) four times. After all codes are erased, the ID codes of all remaining and/or new remote controllers must be re-registered.
- When registering an additional remote controller, the existing ID codes in memory may or may not be erased. If four ID codes are stored in memory, when an additional code is registered, only the oldest code is erased. If less than four ID codes are stored in memory, when an additional ID code is registered the new ID code is added and no ID codes are erased.
- If you need to activate more than two new remote controllers, repeat the procedure "Additional ID code entry" for each additional new remote controller.
- A maximum of four ID codes may be entered. When more than four ID codes are entered, the ID oldest code will be erased.
- For the procedure to memorize position for automatic drive positioner, refer to "PROCEDURE FOR STORING MULTI-REMOTE CONTROLLER".
- Even if the same ID code that is already in the memory is input, the same ID code can be entered. The code is counted as an additional code.




Remote Controller Battery Replacement