Multi-Remote Control System
System DescriptionINPUTS
When the key switch is ON (ignition key is inserted in the key cylinder), ground is supplied
- through key switch terminal 1
- to smart entrance control unit terminal 35.
When the front door switch LH is OPEN, ground is supplied
- to smart entrance control unit terminal 34
- through front door switch LH terminal 2
- through front door switch LH body ground.
When the front door switch RH is OPEN, ground is supplied
- to smart entrance control unit terminal 9
- through front door switch RH terminal 2
- through front door switch RH body ground.
When the sliding door switches are OPEN, ground is supplied
- to smart entrance control unit terminal 41
- through sliding door switches terminal 1
- through the sliding door switches body grounds.
When back door latch switches are OPEN, ground is supplied
- to smart entrance control unit terminal 24
- through back door latch switches terminal 1
- through back door latch switches terminal 2
- through body ground D204.
Remote controller signal is input to the smart entrance control unit. (The antenna of the system is combined with smart entrance control unit).
The Multi-Remote Control System Controls Operation of the
- power door lock
- interior lamp
- panic alarm
- door lock verification
- automatic drive positioner
OPERATED PROCEDURE
Power Door Lock Operation
Smart entrance control unit receives a LOCK signal from remote controller. Smart entrance control unit locks all doors with input of LOCK signal from remote controller.
When an UNLOCK signal is sent from remote controller once, front door LH will unlock.
If an UNLOCK signal is sent from remote controller again within 5 seconds, all other doors will be unlocked.
Door Lock Verification
Power is supplied at all times
- to tail lamp relay terminals 2 and 3 and
- through 15 A fuse (No.42, located in the fusible link and fuse box)
- to horn relay terminals 2 and 3.
When smart entrance control unit receives LOCK or UNLOCK signal from remote controller with all doors closed, ground is supplied
- to tail lamp relay terminal 1
- through smart entrance control unit terminal 26 and
- to horn relay terminal 1
- through smart entrance control unit terminal 21
Tail lamp relay and horn relay are now energized, and side marker, tail, and license lamps flash and horn sounds as a reminder (if horn chirp function is activated)
The lamp and horn reminder has a horn chirp mode and a non-horn chirp mode.
Operating Function Of Door Lock Verification
How to change door lock verification mode
When LOCK and UNLOCK signals are sent from the remote controller for more than 2 seconds at the same time, the door lock verification mode is changed and side marker, tail and license lamps flash and horn sounds as follows:
Interior Lamp Operation
When the following input signals are both supplied:
- door switch CLOSED (when all doors are closed);
- front door LH LOCKED;
Multi-remote control system turns on interior lamp (for about 30 seconds) with input of UNLOCK signal from remote controller.
For detailed description, refer to "INTERIOR ROOM LAMP".
Panic Alarm Operation
Multi-remote control system turns on and off horn and headlamp intermittently with input of PANIC ALARM signal from remote controller.
For detailed description, refer to "VEHICLE SECURITY (THEFT WARNING) SYSTEM".