Steering Wheel Turning Force

Checking Steering Wheel Turning Force





1. Park vehicle on a level, dry surface and set parking brake.
2. Run engine at idle speed or 1,000 rpm.
3. Bring power steering fluid up to operating temperature.
^ Make sure fluid temperature in reservoir tank rises to 60 to 80°C (140 to 176°F).
^ Tires need to be inflated to normal pressure.
4. Check steering wheel turning force when steering wheel has been turned 3600 from the neutral position.
Steering wheel turning force: 39 N (4 kg, 9 lb) or less





5. If steering wheel turning force is out of specification, check rack sliding force.
a. Disconnect steering column lower joint and knuckle arms from the gear.
b. Start and run engine at idle to make sure steering fluid has reached normal operating temperature.
c. Pull tie-rod slowly to move it from neutral position to ± 1.5 mm ( ± 0.453 inch) at speed of 3.5 mm (0.138 inch)/s. Check that rack sliding force is within specification.
Average rack sliding force: 108 - 284 N (11 - 29 kg, 24 - 64 lb)
Maximum rack sliding force: 324 N (33 kg, 73 lb)
6. If rack sliding force is not within specification, refer to Hydraulic System Inspection.
Checking Hydraulic System

7. If rack sliding force is OK, inspect steering column.