Suspension: Service and Repair

Removal and Installation





CAUTION:
^ Before removing the rear suspension assembly, disconnect the ABS wheel sensors from the assembly. Failure to do so may result in damaged sensor wires and the sensor becoming inoperative.
^ Drain brake fluid before disconnecting brake lines.





1. Support axle and suspension components with a suitable jack and block.
2. Disconnect brake hydraulic lines at axle and parking brake cables at back plates.
3. Disconnect ABS wheel sensors from the assembly.
4. Remove LSV spring bracket.
5. Remove upper end nuts and bolt of shock absorbers.
6. Remove stabilizer bar from body.
7. Remove leaf spring from body.





^ Final tightening for rubber parts must be carried out under unladen condition* with tires on ground.
Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions.