Inspection

INSPECTION

Reverse Clutch Snap Ring and Spring Retainer
Check for deformation, fatigue or damage.



Reverse Clutch Return Springs (VG33E only)

Return Springs / 1 Of 2:

Return Springs / 2 Of 2:

Check for deformation or damage. Also measure free length and outside diameter.







Reverse Clutch Drive Plates
Check facing for burns, cracks or damage.

Measure thickness of facing.

Thickness of drive plate:
Standard value:....................1.90 - 2.05 mm (0.0748 - 0.0807 inch)
Wear limit:.............................1.80 mm (0.0709 inch)

If not within wear limit, replace.


Reverse Clutch Dish Plate
Check for deformation or damage.






Reverse Clutch Piston
Shake piston to assure that balls are not seized.

Apply compressed air to check ball oil hole opposite the return spring. Make sure there is no air leakage.

Also apply compressed air to oil hole on return spring side to assure that air leaks past ball.