Supercharger: Service and Repair

Supercharger:

Removal

CAUTION: Do not disassemble or adjust the supercharger.

1. Disconnect the negative battery cable.





2. Disconnect the accelerator cable from the throttle body and the air inlet tube bracket.
3. Disconnect the ASCD cable from the throttle body and the air inlet tube bracket, if equipped.





4. Remove the air inlet duct
- Disconnect the PCV hoses.
- Disconnect the resonator hose.

5. Partially drain the cooling system.





6. Remove the supercharger pulley cover and the supercharger/air conditioning drive belt.





7. Remove the air inlet tube upper and lower supports.





8. Remove the air inlet tube bolts, nuts, and studs. Position the air inlet tube aside.
- Disconnect the evaporative emission vacuum hose.
- Disconnect the brake booster vacuum hose.
- Disconnect the TPS sensor electrical connector.
- Disconnect the TPS switch electrical connector.





9. Remove the supercharger bolts and the supercharger assembly.
- Disconnect the boost control valve vacuum hose.
- Disconnect the PCV hose.



Installation
To install the supercharger, follow the removal steps in reverse order.
- Replace all gaskets; make sure that all gasket surfaces are clean and undamaged.
- Follow all torque sequences for tightening.
- Refill the cooling system.