Diagnostic Procedure 5
DIAGNOSTIC PROCEDURE 5 / With CONSULT-II Scan ToolInspecting SRS intermittent malfunction by using CONSULT-II - Diagnosis mode
1. Turn ignition switch OFF.
2. Connect CONSULT-II to data link connector.
3. Turn ignition switch ON.
4. Touch "START".
5. Touch "AIR BAG".
6. Touch "SELF-DIAG [PAST]".
7. If self-diagnosis result is displayed on "SELF-DIAG [PAST]", go to step 10.
If no malfunction is detected on "SELF-DIAG [PAST]" touch "BACK" and go back to "SELECT DIAG MODE".
8. Touch "TROUBLE DIAG RECORD".
NOTE: With "TROUBLE DIAG RECORD", self-diagnosis results previously erased by a reset operation can be displayed.
9. Self-diagnosis result is displayed on "TROUBLE DIAG RECORD".
10. Touch "PRINT".
11. Compare self-diagnosis result to "Intermittent Malfunction Diagnostic Code Chart".
12. Touch BACK" key of CONSULT-II until "SELECT SYSTEM" appears.
13. Turn ignition switch OFF, then turn off and disconnect CONSULT-II, and both battery cables.
14. Repair the system as outlined by the repair order that corresponds to the self-diagnosis result in "Intermittent Malfunction Diagnostic Code Chart".
15. Go to "DIAGNOSTIC PROCEDURE 3" for final checking.
Diagnostic Procedure 3