Operation

OPERATION

Set Operation
To activate the ASCD all of following conditions must exist
- ASCD control unit receives ON-OFF switch ON signal
- Power supply to ASCD control unit terminal 8 [Brake and clutch pedal is released (M/T) and brake pedal is released and A/T selector lever is in other than P and N position (A/T)].
- Vehicle speed is between 40 km/h (25 MPH) and 144 km/h (89 MPH). (Signal from combination meter.)

When the COAST/SET switch is depressed ground is supplied
- to ASCD control unit terminal 11
- from ASCD steering switch terminal 13.

Then ASCD motor actuator is activated to control throttle wire and ASCD control unit supplies ground
- to combination meter terminal 37 to illuminate SET indicator
- from ASCD control unit terminal 18.

A/T Overdrive Control during Cruise Control Driving (A/T)

VG33E AND VG33ER MODELS
When the vehicle speed is approximately 5 km/h (3 MPH) below set speed a signal is sent
- from ASCD control unit terminal 10
- to TCM terminal 24.

When this occurs the TCM cancels overdrive.
When vehicle speed returns to approximately 0.6 km/h (0.4 MPH) below set speed overdrive is reactivated.

Coast Operation
When the COAST/SET switch is depressed during cruise control driving ASCD motor actuator returns the throttle cable to decrease vehicle set speed until the switch is released. Then ASCD will keep the new set speed.

If COAST/SET switch is pressed and released quickly during cruise control driving vehicle set speed will be reduced by 1.6 km/h (1.0 MPH).

Accel Operation
When the RES/ACCEL switch is depressed ground is supplied
- from ASCD steering switch terminal 13
- to ASCD control unit terminal 11.

If the RES/ACCEL switch is depressed during cruise control driving ASCD motor actuator pulls the throttle cable to increase the vehicle speed until the switch is released or vehicle speed is reached to maximum controlled speed by the system. Then ASCD will keep the new set speed.

If RES/ACCEL switch is pressed and released quickly during cruise control driving vehicle set speed will be increased by 1.6 km/h (1.0 MPH).

Cancel Operation
When any of following conditions exist cruise operation will be canceled
- CANCEL switch is depressed. (Ground is supplied to ASCD control unit terminal 11)
- Brake pedal is depressed. (Power is supplied to ASCD control unit terminal 23 from stop lamp switch)
- Brake or clutch pedal is depressed (M/T) brake pedal is depressed or A/T selector lever is shifted to P or N position (A/T). (Power supply to ASCD control unit terminal 8 is interrupted.)

If ON-OFF switch is turned to OFF when ASCD is activated all of ASCD operation will be canceled and vehicle speed memory will be erased.

Resume Operation
When the RES/ACCEL switch is depressed after cancel operation other than depressing ON-OFF Switch is performed vehicle speed will return to last set speed. To resume vehicle set speed vehicle condition must meet following conditions
- Brake pedal is released.
- Clutch pedal is released (M/T).
- A/T selector lever is in other than P and N position (A/T).
- Vehicle speed is between 40 km/h (25 MPH) and 144 km/h (89 MPH).