Turn Signals: Description and Operation

TURN SIGNAL OPERATION
With the hazard switch in the OFF position and the ignition switch in the ON or START position power is supplied
- through 7.5 A fuse [No.2 located in the fuse block (J/B)]
- to hazard switch terminal 2
- through hazard switch terminal 1
- to combination flasher unit terminal B
- through combination flasher unit terminal L
- to turn signal switch terminal 1.

Ground is supplied to combination flasher unit terminal E through body grounds M14 and M68.

LH Turn
With the turn signal switch in the LH position power is supplied from turn signal switch terminal 3 to
- front combination lamp LH terminal 1
- combination meter terminal 12 and
- rear turn signal lamp LH terminal +.

Ground is supplied to front combination lamp LH terminal 2 through body grounds E12 and E54.

Ground is supplied
- to rear turn signal lamp LH terminal - and
- to combination meter terminal 13
- through body grounds M14 and M68.

With power and ground supplied the combination flasher unit controls the flashing of the LH turn signal lamps.

RH Turn
With the turn signal switch in the RH position power is supplied from turn signal switch terminal 2 to
- front combination lamp RH terminal 1
- combination meter terminal 14 and
- rear turn signal lamp RH terminal +.

Ground is supplied to the front combination lamp RH terminal 2 through body grounds E12 and E54.

Ground is supplied
- to the rear turn signal lamp RH terminal - and
- to combination meter terminal 13
- through body grounds M14 and M68.

With power and ground supplied the combination flasher unit controls the flashing of the RH turn signal lamps.