Disassembly

DRIVE SHAFT / Front Axle:

DISASSEMBLY / Final Drive Side (TS82F)
1. Remove plug seal from slide joint housing by lightly tapping around slide joint housing.
2. Remove boot bands.





3. Move boot and slide joint housing toward wheel side, and apply matching marks.





4. Remove snap ring.





5. Detach spider assembly with press.





6. Draw out boot.
Cover drive shaft serration with tape to prevent damaging the boot.

DRIVE SHAFT / Front Axle:

Wheel Side (ZF100)

CAUTION: The ZF100 type (wheel side) joint assembly has two types of boot material; one is made of rubber and the other is made of plastic.
Do not disassemble the joint assembly with the plastic boot. If the boot or joint is damaged, replace the drive shaft assembly.







The procedures for the joint with the rubber boot are as follows:
* Before separating joint assembly, put matching marks on drive shaft and joint assembly.
* Separate joint assembly with suitable tool.

NOTE: Be careful not to damage threads on drive shaft.

* Remove boot bands.