Assembly

ASSEMBLY






1. Install needle bearing onto one-way clutch inner race.
- Pay attention to its direction-Black surface goes to rear side.
- Apply petroleum jelly to needle bearing.





2. Install oil seal and D-ring onto piston.
Apply ATF to oil seal and D-ring.





3. Install piston by rotating it slowly and evenly.
Apply ATF to inner surface of transmission case.





4. Install return springs, spring retainer and low one-way clutch inner race onto transmission case.
5. Install dish plate, low and reverse brake drive plates, driven plates and retaining plate.
6. Install snap ring on transmission case.





7. Check operation of low and reverse brake clutch piston.





8. Measure clearance between retaining plate and snap ring. If not within allowable limit, select proper retaining plate.

Specified clearance:
Standard......................0.8 - 1.1 mm (0.031 - 0.043 inch)

Allowable limit
VG33E only:.......................2.5 mm (0.098 inch)
VG33ER only:..............................2.7 mm (0.106 inch)





9. Install low one-way clutch inner race seal ring.
- Apply petroleum jelly to seal ring.
- Make sure seal rings are pressed firmly into place and held by petroleum jelly.